Train Engineer Revolution CRE57000 IN STOCK

This starter pack contains

Transmitter, Receiver, simple mounting board, Smoke unit controller, capacitor (for track operation), linking extension button, accessory harness & instruction CD

Technical details

2.4 GHz worldwide universal frequency that is glitch free with each signal packet bound to the individual receiver.
· Either track or battery power.
· 1024 Steps of resolution for smooth operation.
· Easy Multiple Unit (MU) set up and dropping without re-binding.
· Each M.U.’s unit can revert back to single unit operation immediately after being dropped maintaining all original programming.
· Each M.U.’d unit can be set individually to equalize disparate loco operation.
· No program track needed.
· Changes to loco operation can be made on the fly, though it’s safer to stop the train while re-programming to test the results.
· No booster power supply needed.
· Direction of loco shows on screen before operation begins.
· Battery power as well as track power.
· All decoders are R/F (radio frequency) and digital with 5 Amp capacity continuous and 8 amp peak. The pin and socket combined allow this higher amperage along with the high grade mossfets and a huge heat sink.
· Two-way transponding communication between receiver and transmitter.
· Direct communication via radio waves to the loco eliminates track condition elements.
· All stop as well as individual loco stopping.
· Back lit scrolling LCD screen with all commands selectable on the screen.
· No CV variable commands to memorize.
· Short antenna of 1 ½” is easy to place in the loco and reception is top grade regardless of position of antenna.
· Transmitter has belt clip or can fit in shirt pocket.
· Control up to 50 locos and switches from the one transmitter without a base station.
· Future control of accessories through transponding signals as train approaches.
· Rechargeable battery connection in the Transmitter.
· Can use automated sounds via magnets and reed switch control.
· Has 6 outputs on board for sounds and lights and there is an optional board for 16 more controls.
· All programs stored in the transmitter, not the receiver, with signal packet commands sent 1,000 times per second.
· Battery life in transmitter up to one month depending on the amount of usage.
· Future routing of trains in memory including stops.
· Stationary receivers can control up to 4 remote switches. Can M.U. switches in groups up to 24 to change with one button push.
· Easy plug and play ports as well as loco wiring installation.
· Visual identification of locos by name and road number on screen.
· Speed indicator of loco on screen with 2-way communication.
· Short circuit and overheating indication of loco on the screen.
· Easy instructions enabled with screen selection choices.
· Long range of 400+ feet in most environments.
· No motor suppression required as our 2.4 frequency is not affected by motor radio noise.
· Silent operation without any motor hum. Frequency of 15 KHz PWC to keep the sounds above that of human hearing.
· Separate smoke control off board to compensate for the higher voltage needed in smoke systems. Each board can control two smoke systems.
· Transmitter sleep mode time set by user and awakes with the touch of any button